郭海洋,陈康,张烨,刘燕平,张玉梅,邱高
GUO Hai-yang,CHEN Kang,ZHANG Ye,LIU Yan-ping,ZHANG Yu-mei,QIU Gao

• 1:东华大学材料科学与工程学院
• 2:东华大学纺织学院产业用纺织品教育部工程研究中心

摘要(Abstract)：

探究了在热定形过程中超喂率对大直径涤纶单丝结构与力学性能的影响。对制备的单丝进行了拉伸和热收缩性能测试,并通过广角X射线衍射、小角X射线散射及声速取向等方法对微观结构进行了表征。结果表明,随着超喂率的降低,单丝在热定形中受到的张力增大,有利于链段沿着拉伸方向排入晶格,结晶度小幅上升,而在纤维径向上的晶粒尺寸及片晶直径减小。超喂率对单丝非晶区结构影响显著,低超喂率下获得的单丝内部形成的非晶区分子链的取向程度大且含量低,导致纤维断裂强度及初始模量较大且断裂伸长低。此外,低超喂率条件下单丝纤维非晶区取向高,致使热收缩率较大。
The effect of overfeeding rates on the microstructure and mechanical properties of large diameter polyester monofilaments during heat-setting process was investigated. The tensile and thermal shrinkage properties of prepared polyester monofilaments were evaluated, and underlying microstructures were also characterized by using wide-angle X-ray diffraction, small-angle X-ray scattering, and sonic orientation.The tensions within the samples increased with the decrease of the overfeeding rate during the heat-setting process, which was beneficial for the molecular chain to be discharged into the lattice along the stretching direction, resulting in the increase of the crystallinity slightly as well as the decrease of crystal size in the fiber axis and lamellar diameter. The overfeeding rate has a significant effect on the amorphous structure of the monofilament. The monofilament with high-oriented and low-fraction amorphous were formed at a low overfeeding rate, leading to the high breaking strength and initial modulus as well as low elongation at break. In addition, the monofilament with high amorphous orientation under low overfeeding rate has a high thermal shrinkage.

关键词(KeyWords)： 涤纶单丝;超喂率;微观结构
polyester monofilament;overfeeding rate;microstructure

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金项目(项目号11702062);; 上海市浦江人才计划(项目号17PJ1400300)

作者(Author): 郭海洋,陈康,张烨,刘燕平,张玉梅,邱高
GUO Hai-yang,CHEN Kang,ZHANG Ye,LIU Yan-ping,ZHANG Yu-mei,QIU Gao

DOI: 10.16090/j.cnki.hcxw.2020.05.001

参考文献(References)：

• [1] LIU Y, HU H. Compression property and air permeability of weftknitted spacer fabrics[J]. Journal of the Textile Institute, 2011, 102(4):366-372.
• [2]李超,孙婉,贾西苑,等.经编间隔织物的应用及其发展[J].产业用纺织品, 2016, 34(5):31-33.
• [3]芦长椿.高性能单丝技术发展及其产品开发[J].纺织导报, 2011(4):72-76, 78.
• [4]王显楼.涤纶单丝生产工艺对其结构和性质的影响[J].合成纤维,1986, 15(2):30-34.
• [5] SAMUELS, ROBERT J. Morphology of deformed polypropylene. Quantitative relations by combined x-ray, optical, and sonic methods[J]. Journal of Polymer Science Part A Polymer Chemistry, 1965, 3(5):1741-1763.
• [6] YANG X, YU J C, TIAN F, et al. The combined effect of heat-draw ratios and residence time on the morphology and property of aromatic copolysulfonamide fibers[J]. Rsc Advances, 2015, 5(34):27163-27167.
• [7] YU J C, CHEN K, LI X Y, et al. Performance and structure changes of the aromatic co-polysulfonamide fibers during thermal-oxidative aging process[J]. Journal of Applied Polymer Science, 2016, 133(41):44078-44088.
• [8] YU J C, TIAN F, CHEN S H, et al. Structure and property development of aromatic copolysulfonamide fibers during wet spinning process[J]. Journal of Applied Polymer Science, 2015, 132(31):42343-42350.
• [9] CHEN K, YU J, LIU Y, et al. Creep deformation and its correspondence to the microstructure of different polyester industrial yarns at room temperature[J]. Polymer International, 2019, 68(3):555-563.
• [10] HUISMAN R, HEUVEL H M. The effect of spinning speed and drawing temperature on structure and properties of poly(ethylene terephthalate)yarns[J]. Journal of Applied Polymer Science, 1989, 37(3):595-616.
• [11] ALEXANDER L E. X-ray diffraction methods in polymer science[M]. New York:Wiley-Interscience, 1969.
• [12] MURTHY N S, BEDNARCZYK C, MOORE R A F, et al. Analysis of small-angle X-ray scattering from fibers:Structural changes in nylon 6upon drawing and annealing[J]. Journal of Polymer Science Part B Polymer Physics, 1996, 34(5):821-835.
• [13] MURTHY N S, GRUBB D T. Tilted lamellae in an affinely deformed3D macrolattice and elliptical features in small-angle scattering[J]. Journal of Polymer Science Part B Polymer Physics, 2006, 44(8):1277-1286.
• [14] MURTHY N S, GRUBB D T, ZERO K. Structural implications of the elliptical form of small-angle reflections in oriented semicrystalline polymers[J]. Macromolecules, 2000, 33(3):1012-1021.
• [15] YU J C, WANG R, YANG C L, et al. Morphology and structure changes of aromatic copolysulfonamide fibers heat-drawn at various temperatures[J]. Polymer International, 2014, 63(12):2084-2090.
• [16] MURTHY N S, GRUBB D T. Deformation in lamellar and crystalline structures:in situ simultaneous small-angle X-ray scattering and wideangle X-ray diffraction measurements on polyethylene terephthalate fibers[J]. Journal of Polymer Science:Part B:Polymer Physics, 2003, 41(13):1538-1553.
• [17] LIU Y T, YIN L X, ZHAO H R, et al. Insights into process-structureproperty relationships of poly(ethylene terephthalate)industrial yarns by synchrotron radiation WAXD and SAXS[J]. Journal of Applied Polymer Science, 2015, 132(36):42512-42522.
• [18] SAMUI B K, PRAKASAN M P, RAMESH C, et al. Structure-property relationship of different types of polyester industrial yarns[J]. Journal of the Textile Institute, 2013, 104(1):35-45.