聚乳酸长丝与亚麻-黏胶纱的并捻工艺及性能Properties and Doubling-Twisting Process of PLA Filament and Rayon-Linen Blended Yarn
肖云超,刘淑强,吴改红,戴晋明
XIAO Yun-chao,LIU Shu-qiang,WU Gai-hong,DAI Jin-ming
摘要(Abstract):
采用并捻联合纺纱方法,将聚乳酸长丝与亚麻-黏胶单纱直接并合加捻成复合纱线,并对影响其纱线结构和性能的因素(捻因数、张力、钢丝圈)进行了研究分析,随后通过捻因数与钢丝圈正交试验优化得出最佳的并捻纺纱工艺。研究分析得出:并捻纱的断裂强力随着捻因数的增大先增大后减小;钢丝圈号数对并捻纱断裂强力存在着较大的影响;并捻纱的纱线结构类似于包缠纱,一般张力大的组分为纱芯,另一组分在外层螺旋包覆纱芯。最佳并捻工艺参数为:捻因数220,钢丝圈选14号。
In order to develop PLA blended yarn with moisture absorption and breathable properties, the doubling and twisting spinning method was adopted. PLA filament and rayon-linen blended yarn were twisted into composite yarn directly. The parameters which might influence the structure and properties of composite yarn, including twist factor, traveler and tension were researched. And then the best process of doubling and twisting was optimized through the orthogonal experiment. The experimental results showed that the tensile strength of composite yarn firstly increased and then decreased with the increase of the twist factor. Traveler number also had a great effect on the tensile strength of twisted yarn. The structure of twisted yarn was similar to the wrapped yarn. And the optimum parameters of doubling and twisting process were as follows: twist factor 220, traveler number 14.
关键词(KeyWords):
聚乳酸长丝;亚麻-黏胶;并捻纱;捻因数;钢丝圈
PLA filament,rayon-linen,doubling and twisting yarn,twist factor,traveler
基金项目(Foundation): 山西省高等学校大学生创新创业训练项目(2013067);; 太原理工大学校基金项目(2012L074,2013T020,2013T021,2013T022);; 太原理工大学教育教学改革项目(201330);; 山西省留管委项目(2012-044)
作者(Author):
肖云超,刘淑强,吴改红,戴晋明
XIAO Yun-chao,LIU Shu-qiang,WU Gai-hong,DAI Jin-ming
DOI: 10.16090/j.cnki.hcxw.2014.02.018
参考文献(References):
- [1]刘淑强,闫承花,郭洁丽,等.可降解聚乳酸纤维的研究进展[J].轻纺工业与技术,2011,40(6):45-48.
- [2]赵金龙,沈兰萍,徐玲.聚乳酸纤维抗菌织物[J].合成纤维,2013,42(5):46-49.
- [3]熊葳.聚乳酸纤维的结构与性能[J].现代丝绸科学与技术,2010(3):36-40.
- [4]吴改红,刘淑强,荆云娟,等.可生物降解聚乳酸并捻长丝纱的制备及性能研究[J].丝绸,2013,50(3):14-18.
- [5]岳仕芳,张娟娟.亚麻色纺纱高效短流程生产工艺研究与实践[J].纺织学报,2013,34(1):84-89.
- [6]杨保生,范向东.黏胶亚麻混纺纱线的前处理工艺[J].印染,2005(10):29-30.
- [7]练军.长丝短纤复合纱线强伸性能与加捻关系研究[J].棉纺织技术,2003,31(3):21-24.
- [8]郑兵,程智,潘六一.浅谈钢丝圈纺纱条件及使用注意事项[J].棉纺织技术,2004,32(9):45-46.
- [9]施楣梧,张腾,张建春,等.长丝短纤纱并捻复合工艺对纱线力学性能的影响[J].棉纺织技术,2002,30(7):26-28.
- [10]张军英.并捻工艺对Coolmax复合纱性能的影响研究[J].上海纺织科技,2006,32(12):36-37.