彭朝荣,林义,邓华川,陈竹平,姚永毅
PENG Chao-rong1,LIN Yi2,DENG Hua-chuan1,CHEN Zhu-ping1,YAO Yong-yi2(1.Sichuan Institute of Atomic Energy

• 1:四川省原子能研究院
• 2:四川大学纺织研究所

摘要(Abstract)：

采用50%苯酚和50%1,1,2,2-四氯乙烷的混合溶液为溶剂,通过气流-静电纺丝法制备了聚对苯二甲酸乙二酯(PET)纳米纤维。利用扫描电镜(SEM),研究了聚合物分子质量、溶液浓度、电压、接收距离(喷丝孔到接收板的距离)对电纺纤维形态结构的影响。结果表明:随着聚合物分子质量和溶液浓度增加,纤维平均直径也随之增加;纤维平均直径随电压的增加而减小;随接收距离的增加,纤维平均直径先减小后增加。最佳工艺条件为:聚合物特性黏度为0.818 dL/g,溶液质量分数为15%,电压为32 kV,接收距离为23 cm,所得PET电纺纳米纤维平均直径为85 nm。
The nanofibers of poly(ethylene terephthalate)(PET) were prepared by gas-jet/electrospinning from its solutions of 50 % phenol and 50 % 1,1,2,2-tetrachloroethane.The influences of the molecular weight,the concentration,the applied voltage and the tip-collector distance(TCD) on the diameter and morphology of electrospun fibers were investigated by scanning electron microscopy(SEM).It was found that the fiber diameter was increased as the increases in the molecular weight and the concentration.The average diameter of gas-jet/electrospun fibers was reduced as the applied voltage increased from 27.5 kV to 32 kV.The experimental results also showed that the fiber diameter was decreased firstly and then increased with increasing the TCD from 18 cm to 29 cm.These PET nanofibers with average diameter of about 85 nm could be prepared by this gas-jet/electrospinning at the following optimal process parameters: the intrinsic viscosity of PET was 0.818 dL/g,the concentration was 15 %,the applied voltage 32 kV,the TCD 23 cm.

关键词(KeyWords)： 静电纺丝;纳米纤维;PET;气流-静电纺
electrospinning,nanofiber,PET,gas-jet/electrospinning

Abstract:

Keywords:

基金项目(Foundation):

作者(Author): 彭朝荣,林义,邓华川,陈竹平,姚永毅
PENG Chao-rong1,LIN Yi2,DENG Hua-chuan1,CHEN Zhu-ping1,YAO Yong-yi2(1.Sichuan Institute of Atomic Energy

参考文献(References)：

• [1]Wang J,Huang N,et al.The effects of amorphous carbon films de-posited on polyethylene terephthalate on bacterial adhesion[J].Biomateri-als,2004,25:3 163-3 170.
• [2]饶天健,金跃辉,慕小瑜等.重建韧带的新材料聚对苯二甲酸乙二酯复合毡型人工韧带研究[J].上海医学,2006,29:469-472.
• [3]吴大诚,杜仲良,高绪珊.纳米纤维[M].北京:化学工业出版社,2003:42.
• [4]Li D,Xia Y N.Electrospinning of nanofibers:reinventing the wheel[J].Advanced Materials,2004,16:1 151-1 170.
• [5]Hong K H,Kang T J.Hydraulic permeabilities of PET and Nylon 6electrospun fiber webs[J].Journal of Applied Polymer Science,2006,1006:167-177.
• [6]Kim K W,Lee K H,et al.The effect of melecular weight and the linear velocity of drum surface on the properties of electrospun poly(ethyleneterephthalate)nonwovens[J].Fibers and Polymers,2004,5:122-127.
• [7]王佩杰,李从举,常敏等.溶剂对电纺聚酯纳米纤维可纺性的影响[J].合成纤维工业,2007,30(2):11-13.
• [8]Ma Z W,Kotaki M,et al.Surface engineering of electrospun polythy-lene terephthalate(PET)nanofibers towards development of a new materialfor blood vessel engineering[J].Biomaterials,2005,26:2 527-2 536.
• [9]王颖俊,高长有.溶剂挥发性对PLGA电纺纤维直径及其膜动态力学性能的影响[J].组织工程与重建外科杂志,2007,3(1):7-10.
• [10]姚永毅,朱谱新,吴大诚等.静电纺丝法和气流-静电纺丝法制备聚砜纳米纤维[J].高分子学报,2005,(5):687-692.
• [11]李旭清,周虹,姚永毅等.气流-静电纺丝法制备苯乙烯-丁二烯-苯乙烯嵌段共聚物超细纤维[J].合成纤维,2007,36(9):14-18.
• [12]Haghi A K,Akbari M.Trends in electrospinning of naturalnanofibers[J].Physica Status Solidi A-Applications and Materials Sci-ence,2007,204:1 830-1 834.
• [13]Koski A,Yim K,Shivkumar S.Effect of molecular weight on fibrousPVA produced by electrospinning[J].Materials Letters,2004,58:493-497.
• [14]Zong X H,Kim K,et al.Structure and process relationship of elec-trospun bioabsorbable nanofiber membranes[J].Polymer,2002,43:4 403-4 412.
• [15]方壮熙,张璐,韩涛等.PHBV电纺纤维结构与形态的研究[J].高分子学报,2004,(4):500-505.
• [16]Subbiah T,Bhat G S,et al.Electrospinning of nanofibers[J].Journalof Applied Polymer Science,2005,96:557-569.