熔体直纺85 dtex/72 f阳离子涤纶预取向丝工艺探讨Process Study on Melt Direct Spinning of 85 dtex/72 f Cationic Dyeable Polyester Pre-Oriented Yarn
宋作强
SONG Zuo-qiang
摘要(Abstract)：
通过调整卷绕速度、环吹风风压和底部加热器温度等工艺条件,以改善熔体直纺85 dtex/72 f阳离子染料可染涤纶预取向丝(CDP-POY)的内在质量。试验表明,当卷绕速度为2 500 m/min、环吹风风压为18 Pa、底部加热器温度为306℃时,CDP-POY的强伸性能和热应力大小在适当范围内。此条件下的纤维在后道加工中的满卷率和降等率分别为92.11%和0.51%,相对其他条件下有明显提升。
The internal quality of 85 dtex/72 f CDP-POY was improved by optimizing the winding speed,the ring cooling wind pressure and the temperature of bottom heater. The results show that the tensile properties and thermal stress of CDP-POY are in the appropriate range when the winding speed is 2 500 m/min,the ring cooling wind pressure is 18 Pa and the temperature of bottom heater is 306 ℃. Under this condition, the full-package rate and degradation ratio in post-processing are 92.11% and 0.51%, respectively,which are significantly better than those under other conditions.
关键词(KeyWords)：
阳离子染料可染涤纶;工艺;拉伸变形丝
cationic dyeable polyester;process;draw textured yarn
基金项目(Foundation):
作者(Author):
宋作强
SONG Zuo-qiang
DOI: 10.16090/j.cnki.hcxw.2021.11.012
参考文献(References)：
- [1] YU S, GUO Z, HONG X Y, et al. Structures and properties of modification copolyester fiber[J]. Advanced Materials Research, 2011, 139:104-108.
- [2]杨洪祥,孙玉.阳离子改性共聚酯纤维结构与性能的研究[J].天津工业大学学报, 2010, 29(4):1-4.
- [3]冉华伟,泮金华,王国正,等.改善熔体直纺涤纶POY后加工条干不匀率的探讨[J].合成纤维, 2020, 49(5):8-12.
- [4]李允成,徐心华.涤纶长丝生产[M]. 2版.北京:中国纺织出版社,1995.
- [5]郭佳佳,李国平,崔利,等.熔体直纺阳离子涤纶预取向丝工艺探讨[J].合成纤维, 2020, 49(5):20-22, 36.