范雨娇
FAN Yu-jiao

• 1:中国航空制造技术研究院

摘要(Abstract)：

研究了两种典型的中温胶膜——FM73M胶膜和J-95胶膜在三种工艺条件下的滚筒剥离性能及剪切性能。试验发现：两种胶膜的物理性能相近；在标准工艺条件下，两种胶膜的滚筒剥离强度和剪切强度都是最高的，而在极限工艺条件下，两种胶膜的滚筒剥离强度和剪切强度都降低；两种胶膜的介电常数基本一致，J-95胶膜的损耗角正切值低于FM73M胶膜的，具有更好的介电性能。
The roller peeling properties and shearing properties of two typical medium temperature adhesive films—FM73 M adhesive film and J-95 adhesive film under three process conditions were mainly studied.The test found that the physical properties of the two adhesive films were similar; under the standard process conditions, the roller peel strength and shear strength of the two adhesive films were the highest, while under the extreme process conditions, the roller peel strength and shear strength of the two adhesive films decreased; the dielectric constants of the two adhesive films are basically the same, and the loss tangent value of the J-95 adhesive film is lower than that of the FM73 M adhesive film, which has better dielectric properties.

关键词(KeyWords)： 蜂窝夹层材料;中温胶膜;工艺条件;剥离强度;剪切强度
honeycomb sandwich material;medium temperature adhesive film;process condition;peel strength;shear strength

Abstract:

Keywords:

基金项目(Foundation):

作者(Author): 范雨娇
FAN Yu-jiao

DOI: 10.16090/j.cnki.hcxw.2022.03.005

参考文献(References)：

• [1]梁恒亮,邱海鹏,陈静,等.铝蜂窝夹层板正交结构件的制造方法[J].航空制造技术, 2009(S1):30-32.
• [2]匡弘,付春明,那万才,等. J-95中温固化载体胶膜[J].中国胶粘剂, 1994(3):30-34.
• [3]何凯,龚志红,徐娟,等. FM73M胶膜及其与PMI泡沫芯的胶接机理[J].宇航材料工艺, 2013, 43(1):82-85.
• [4]袁协尧,王欣晶,见雪珍.操作环境湿度对FM73M胶膜性能的影响[J].化学与黏合, 2015, 37(5):317-320.